Tachometer Adapterwith BargraphPart # TA-01, Price $101.00> Designed especially for the Veglia tachometer. Converts ignition system pulses to trigger the Veglia tach.> Compatible with most ignition systems and ECU's. > Includes an integrated LED bargraph display as a RPM reference tachometer, 1,000 to 10,000 RPM in 1000 RPM increments.> Additional connection for electric choke or relay for operating electric fuel pump.> Replaces MSD-8920 wire for wire.
Generator Light ResistorPart # GLR, Price $29.00
Replace this Mangusta fuse panel with the Pantera-Electronics Mangusta fuse panel for reliability and safety.
The factory resistor is for the alternator and operates warm to hot. This causes the wires to oxidize and weakens the strength of the wire. Eventually the wire breaks just from the vibration of driving. Resoldering the wire doesn’t last long since the wire is now closer to the heat of the resistor.
Brake light Switch Sensor is a non-contact switching device that connects directly to the factory wire harness to activate the brake lights.The Panteras factory hydraulic switch fails slowly requiring higher levels of hydraulic force. The brake lights should activate in advance of developing any brake pressure.This non-contact brake switch uses a semiconductor magnetic sensor to detect the travel of the brake pedal and a semiconductor switch activates the brake lights. The brake lights can be incandescent or LED or combination of both. Since there are no springs or contacts as typical brake switches the repeatability is superior.A unique feature retains the brake lights active for 2 seconds after the brake pedal is released.The 2 second time allows the foot to move from the brake to accelerator while the car is not in motion.
Brake Light SwitchPart # BLS, Price $49.00
Our solution for this resistor is this modern assembly of multiple resistors to spread the heat and terminals for the lamp socket. NO soldering or tools are needed to install and it’s a rugged long lasting construction.This solution also allows our LED Gauge Lamp light to be used for the “GEN” light indicator which will not burn-out !
Gauge Connect System Part # GCS-01, Price $115.00
Gauge Connect System is manufactured with modern wire that is longer than the factory wires so it is not difficult to remove the console plate.The Gauge Connect System replaces the obsolete wire harness with a modern terminals and reduces the number of wires.It replaces aged crimp connections that can be the source of gauge problems.Simple installation, uses wire ties to mount the board.