Improve operation of the condenser fan,
ramp-up speed and delay shut-off. Delay
shut-off cools the condenser for 1 minute
after air conditioner compressor is off.
de Tomaso Pantera Air Conditioner Controller
> Start up-timer does not energize the condenser fan or refrigerant compressor
for 12 seconds to allow maximum battery power for starting of the engine.
> Delay timer keeps the condenser fan running for 1 minute after the A/C
thermostat turns off the compressor. This allows additional cooling of the
condenser and reduce the number of start and stops during short thermostat
cycles.
> Ramped start-up speed for the condenser fan to lower start-up current,
improves life of the motor and reduces current on wire harness. This high
current demand is on the very long wire that extends from the relay box to the
A/C condenser fan.
> All electronic switching of the high current A/C loads, including the horn
switch. Removes electrical arc condition from horn switch contacts.
> Key in ignition switch is an audio tone, an improvement to the dated factory
buzzer sound.
> Compact size, reliable modern electronics, lighter than the factory relay plate
assembly, can be mounted with or without the factory box.
> Connection tabs are labeled with the wire colors and function matching the
wires connected to the relays.
> Switch LED indicators for diagnostics, makes installation easy.
Air Conditioner Controller
Part # ACC-01
Price $210.00 USD
PRODUCTS
Copyright © 2025
Air Condition Controller fits inside factory
Pantera relay panels and relay boxes
This is the 1971 / 1972 Electronic Relay Plate.
The Relay Plate is ONLY the plate with hardware and
wiring. The controllers are NOT included with the Relay
Plate.
To order a Relay Plate for Plug & Play installation the
Headlight Motor Controller, A/C Controller and Turn
Signal Flasher must be ordered together so the wiring
can be completed at Pantera Electronics.
A Wire Harness Extension included with the Relay Plate
to connect to the fuse panel.
1971 / 72 Electronic Relay Plate ONLY.
Includes wire harness, hardware and wiring.
Part # ERP-02, Price $327.00 USD
1973 / 74 Electronic Relay Plate ONLY.
Includes wire harness, hardware and wiring
Part # ERP-04, Price $336.00 USD
1973 / 74
1971 / 72
THIS IS THE PLUG AND PLAY VERSION REPLACING ALL OF THE FACTORY RELAYS
This is the 1973 / 1974 Electronic Relay Plate.
The Relay Plate is ONLY the plate with hardware and wiring.
The controllers are NOT included with the Relay Plate.
To order a Relay Plate for Plug & Play installation the Headlight
Motor Controller, A/C Controller and Turn Signal Flasher must be
ordered together so the wiring can be completed at Pantera
Electronics.
A Wire Harness Extension included with the Relay Plate to connect
to the fuse panel.