de Tomaso Pantera Electrical Components
HOME HOW TO ORDER RECOMMENDATIONS
The only manufacturer of electronic technology designed exclusively for the de Tomaso Pantera
PRODUCTS
All electrical components are electrically tested before entering our inventory. We are the only de Tomaso Pantera vendor that is knowledgeable and possess electronic equipment to offer this service.
Copyright © 2009-2017
We Rescue Your Passion
Gauge Lamp Socket Part # GLS, Price each $8.00
In-line 30 Amp Fuse Holder. for Radiator Fan Controller 48”- 10 AWG wire. 12”- 10 AWG wire. Includes 30A fuse. Part # IFH, Price $10.00 ea.
Courtesy Light Door Switch Part # DSW, Price each $25.00
Hazard Switch Part # HSW, Price $97.00
Coolant Temperature Sender Part # CTS, Price $30.00
Oil Pressure Sender Part # OPS, Price $32.00
Electrically and mechanically equivalent to the factory sender
Electrically and mechanically equivalent to the factory sender
CRITICAL SUPPORT CONTROLS H-P IMPROVED SAFTEY ELECTRONIC IGNITION FUSE PANEL IGNITION SWITCH HEADLIGHT / MOTOR RADIATOR FAN CONSOLE CONTROLLER AIR CONDITIONER ROCKER SWITCHES WINDOW SWITCHES LED GAUGE LAMP LED DOME LAMP LED DOOR JAMB LAMP LED SIGNAL LIGHTS LED TAILLIGHTS LED REVERSE LIGHTS GROUP4  LED LIGHTS LED SIGNAL FLASHER ALTERNATOR KIT WIRE HARNESS ELECTRICAL COMPONENTS
Veglia Tachometer We repair and calibrate the de Tomaso tachometer with precision and accurate electronic test equipment.
We repair the Veglia ammeter by disassembly and replacing the damaged components with redesigned components so that failure will not reoccur. New brass and nickel plated brass hardware is used for connection of the cables. Price $249.00
Temperature Gauge Compensator Part # TGC, Price $25.00
Panteras with the Velgia temperature gauge that has a maximum temperature of 260 and the blue and red colored area will indicate a higher temperature than the actual engine temperature. In order to correct this PE designed the Temperature Gauge Compensator. The Temperature Gauge Compensator adjusts the electrical signal from the sender to equate to the proper temperature indicated on the temperature gauge dial. The Temperature Gauge Compensator does not use a resistor that inhibits the maximum range of the temperature gauge reading. This is critical if higher temperatures are to be indicated. The installation is easily accomplished by disconnecting the sensor wire, inserting the Temperature Gauge Compensator and connecting the wire to the TGC. NO NEED to install on the  sender on engine, installs easily on the temperature gauge.
See “How to Order”
Defective Ammeter with needle offset
Defective ammeter with melted and displaced terminal studs
Restored Ammeter
Low Brake Pressure Switch Part # BPS, Price $20.00
Rotary Wiper Switch (refurbished) Part # RWS, Price $120.00
Temperature Gauge Compensator
Veglia Ammeter